To avoid the need to post drill anchors and the need for required ‘pull-out’ tests for essential leading edge works, GMI Construction Group has adopted cast-in ceiling anchors provided by ScissorSafe.

These are designed so that a void former is fixed to face of the form work and cast within the slab, leaving a void for a removable, re-usable anchor to be inserted to clip onto for restraint connection.

These anchors are designed in such a way that the anchorage tool will not allow a connection until the anchor is fully engaged, and cannot close or slip until the user purposely removes the connector, removing the potential for human error.

When the ScissorSafe tool is looked into the concrete, it provides a 12kN capacity anchorage in any direction. In this scenario, it has been used for providing restraint lines for pre-cast panel installation and restraint anchors at lift entrances for door installation.

To find out more, click the link below.

Go to resource

Footer Reference

Entry submitted by GMI Construction Group

Did you find this article helpful?

Please rate this article

0 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 5 (0 votes, average: 0.00 out of 5)
You need to be a registered member to rate this.

Leave a comment

Return to previous page

The Scheme does not promote or endorse any products, goods or services. For more information, click here.